Installation doesn’t require removal of the driveshaft. The 2-part design clamps around the OEM bearing. The old carrier must be removed, so a cutting tool is required.

Installation with no CSB Spacers

Installation with CSB Spacer Kit for 3.5” JOR Lifted Vehicles

The exact steps to access the carrier will vary slightly by model, but the removal and installation of the new carriers are the same. The basic steps are:

• Remove any braces or splash shields preventing exhaust and heat shield removal
• Remove or lower exhaust in area of center support bearing
• Remove heat shielding covering center support bearing
• Cut off OEM carrier and remove rubber support material with razorblade, leaving base layer of rubber intact on the bearing
• Clamp new carrier around OEM bearing

• 2nd/3rd gen (XL20/XL30/XL40) Toyota Sienna (2004-2020) (AWD Only)
• Also fits:
  • 1st/2nd/3rd gen (XU20/XU40/XU50) Toyota Highlander (2001-2019) (AWD Only)
  • 1st/2nd/3rd/4th gen (XU10/XU30/AL10/AL20) Lexus RX 300/350 (1999-2022) (AWD Only)

Street and Track refer to the durometer (stiffness) of the bushings. Track are roughly twice the durometer of the street bushings. Both track and street are many times stiffer than stock and will hold up to whatever abuse are thrown at them, but the street bushings are better at soaking up drivetrain noise and vibration. Usually both street and track are completely silent and vibration-free, but in cases where there is an underlying drivetrain issue causing the driveshaft to vibrate badly, the track bushings may not be able to soak it all up, where the street bushings can.

We generally recommend street bushings for any car that's not purpose-built for track or overland use, since the street bushings have a much lower chance of transmitting drivetrain NVH to the cabin at high speeds or under heavy throttle loads.

If you’re not sure which to go with, the “Give me Both!” option will give you a full set of each of the street and track bushings. You can use all street, all track, or even mix and match them to find the perfect balance of performance and NVH-absorption.

Full Assemblies

Without 3.5” JOR Lift Spacer Option

Street - TYT02A0-S
Track - TYT02A0-T
Both - TYT02A0-B

With 3.5” JOR Lift Spacer Option

Street - TYT02A1-S
Track - TYT02A1-T
Both - TYT02A1-B

Spare Bushing Sets

Street - 2x BSH09A0
Track - 2x BSH09A1

Spare Hardware Set

Without 3.5” JOR Lift Spacer Option

2x SHS10A1

With 3.5” JOR Lift Spacer Option

SHS11A1

Feel free to contact us at info@mlperformance.co.uk should you wish to double check!

To ensure the part(s) you have ordered fits your vehicle, we run a compatibility check prior to dispatch. We can do this either using your registration number (UK) or the last 7 digits of your VIN. Simply enter your car details prior to checkout.

JXB-TYT02A1

Manufactured by

JXB Performance